Engine Control Module (ECM) - Programming and Setup

ENGINE CONTROL MODULE PROGRAMMING AND SETUP

The following service procedures require either a programming or a setup event performed for a complete repair.

ECM Replacement
If the engine control module (ECM) is replaced, the following procedures must be performed:
1. The ECM Reprogramming-Refer to Service Programming System (SPS).
2. The Turbocharger Learn Procedure-Refer to Turbocharger Learn Procedure.
3. Theft Deterrent-Refer to Programming Theft Deterrent System Components.

ECM Reprogramming
If the engine control module (ECM) needs to be reprogrammed, refer to Service Programming System (SPS).

Setup for Component Replacement
The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, a Turbocharger Learn Procedure must be performed.
- Turbocharger
- Turbocharger Vane Position Sensor.
- Turbocharger Vane Position Control Solenoid Valve