Lubricant Level Inspection - Rear Drive Axle (9.75 Inch Axle)

Lubricant Level Inspection - Rear Drive Axle (9.75 Inch Axle)
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Ensure the vehicle is level.
3. Inspect the rear axle for leaks. Repair as necessary.
4. Clean the area around the rear axle fill plug.





5. Remove the rear axle fill plug.
6. Inspect the lubricant level.
The lubricant level should be between 0 - 4 mm (0 - 0.16 inch) below the fill plug opening.
7. If the level is low, add lubricant until the level is even with the bottom edge of the fill plug opening. Use the proper fluid.

8. Install the rear axle fill plug.
^ Tighten the rear axle fill plug to 21 Nm (15 ft. lbs.).

Notice: Refer to Service Precautions.

9. Lower the vehicle.