Mode Door - Lower (Visteon)

MODE DOOR REPLACEMENT - LOWER (VISTEON)

REMOVAL PROCEDURE
1. Remove the HVAC module assembly.




2. Disconnect the electrical connector (3) from the mode actuator (4).
3. Remove the screws from the mode actuator (4).
4. Remove the mode actuator (4) from the HVAC module assembly (1).
5. Remove the wiring harness from the air distribution housing (1).




6. Remove the screws from the air distribution housing (1).
7. Remove the air distribution housing (1) from the HVAC module assembly (2).




8. Remove the mode door (2) from the air distribution housing (1).

INSTALLATION PROCEDURE




1. Install the mode door (1) to the air distribution housing (1).




2. Install the air distribution housing (1) to the HVAC module assembly (2).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the screws to the air distribution housing (1).

Tighten
Tighten the screws to 2 N.m (18 lb in).

4. Install the wiring harness to the air distribution housing (1).




5. Connect the electrical connector (3) to the mode actuator (4).
6. Install the screws to the mode actuator (4).
7. Install the mode actuator (4) to the HVAC module assembly (1).
8. Install the HVAC module assembly.