Steering Gear Actuator Boot Shield Replacement

Steering Gear Actuator Boot Shield Replacement

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.

Notice: When lifting the vehicle do not allow the jack to touch the rear steering gear. If the jack touches the rear steering gear you may damage the gear or the rack and pinion boots. If the boots are damaged replace the rack and pinion boot.

2. Unsnap the locking tabs on the rack and pinion boot protector (1).
3. Remove the rack and pinion boot protector (1) from the rack and pinion boot (2).

Installation Procedure





1. Install the rack and pinion boot protector (1) to the rack and pinion boot (2).
2. Snap the locking tabs together on the rack and pinion boot protector.
3. Lower the vehicle.