Maintenance II

MAINTENANCE II

1. CHANGE ENGINE OIL AND FILTER. Reset oil life system. Refer to Engine Oil Life System. An Emission Control Service.

2. ALLISON TRANSMISSION ONLY: Replace external spin-on filter only at the first maintenance service performed on the vehicle.

3. LUBRICATE THE CHASSIS COMPONENTS. Lubricate the suspension, steering linkage, transaxle shift linkage and the underbody contact points and linkage.

4. VISUALLY CHECK FOR ANY LEAKS OR DAMAGE. A fluid loss in any vehicle system could indicate a problem. Have the system inspected and repaired and the fluid level checked. Add fluid if needed.

5. INSPECT ENGINE AIR CLEANER FILTER. If necessary, replace filter. An Emission Control Service. The U.S. Environmental Protection Agency or the California Air Resources Board has determined that the failure to perform this maintenance item will not nullify the emission warranty or limit recall liability prior to the completion of the vehicle's useful life. We, however, urge that all recommended maintenance services be performed at the indicated intervals and the maintenance be recorded.

6. ROTATE TIRES AND CHECK INFLATION PRESSURES AND WEAR.

7. INSPECT BRAKE SYSTEM. Visually inspect brake lines and hoses for proper hook-up, binding, leaks, cracks, chafing, etc. Inspect disc brake pads for wear and rotors for surface condition. Inspect other brake parts, including calipers, parking brake, etc.

8. CHECK ENGINE COOLANT AND WINDSHIELD WASHER FLUID LEVELS AND ADD FLUID AS NEEDED.

9. PERFORM ANY NEEDED ADDITIONAL SERVICES. Refer to Additional Required Services.

10. INSPECT SUSPENSION AND STEERING COMPONENTS. Visually inspect front and rear suspension and steering system for damaged, loose or missing parts or signs of wear. Inspect power steering lines and hoses for proper hook-up, binding, leaks, cracks, chafing, etc.

11. INSPECT ENGINE COOLING SYSTEM. Visually inspect hoses and have them replaced if they are cracked, swollen or deteriorated. Inspect all pipes, fittings and clamps. To help ensure proper operation, a pressure test of the cooling system and pressure cap and cleaning the outside of the radiator and air conditioning condenser is recommended at least once a year.

12. INSPECT WIPER BLADES. Visually inspect wiper blades for wear or cracking. Replace blade inserts that appear worn or damaged or that streak or miss areas of the windshield.

13. INSPECT RESTRAINT SYSTEM COMPONENTS. Make sure the safety belt reminder light and all your belts, buckles, latch plates, retractors and anchorages are working properly. Look for any other loose or damaged safety belt system parts. If you see anything that might keep a safety belt system from doing its job, have it repaired. Have any torn or frayed safety belts replaced. Also look for any opened or broken air bag coverings, and have them repaired or replaced. (The air bag system does not need regular maintenance.)

14. LUBRICATE BODY COMPONENTS. Lubricate all key lock cylinders, hood latch assembly, secondary latch, pivots, spring anchor, release pawl, rear compartment hinges, outer liftgate handle pivot points, rear door detent link, roller mechanism, liftgate handle pivot points, latch bolt, fuel door hinge, cargo door hinge, locks and folding seat hardware. More frequent lubrication may be required when exposed to a corrosive environment. Applying silicone grease on weather-strips with a clean cloth will make them last longer, seal better and not stick or squeak.

15. CHECK TRANSMISSION FLUID LEVEL AND ADD FLUID AS NEEDED.