EVAP Canister Replacement (Pickup)

EVAPORATIVE EMISSION (EVAP) CANISTER REPLACEMENT (PICKUP)

REMOVAL PROCEDURE

IMPORTANT: Clean all evaporative emission (EVAP) connections and surrounding areas prior to disconnecting the lines in order to avoid possible system contamination.




1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the EVAP canister vent solenoid (CVS) line from the EVAP canister.
3. Disconnect the fuel tank EVAP line from the canister.
4. Disconnect the canister EVAP line from the fuel bundle line.
5. Remove the EVAP canister nut.
6. Remove the EVAP canister with shield from the bracket.
7. If necessary, remove the EVAP canister from the shield, perform the following:
1. Lift up the retaining clip on the bottom of the canister.
2. Remove the canister from the shield.
8. If necessary, disconnect the EVAP lines from the canister.

INSTALLATION PROCEDURE




1. If necessary, connect the EVAP lines to the canister.
2. If necessary, install the EVAP canister to the shield, perform the following:
1. Install the canister to the shield.
2. Ensure the retaining clip engages on the bottom of the canister.
3. Install the EVAP canister with shield to the bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the EVAP canister nut.

Tighten the nut to 25 N.m (18 lb ft).

5. Connect the canister EVAP line to the fuel bundle line.
6. Connect the fuel tank EVAP line to the canister.
7. Connect the EVAP CVS line to the canister.
8. Lower the vehicle.