Power Steering Hose Assembly Replacement (Rack and Pinion

Power Steering Hose Assembly Replacement (Rack and Pinion)

Removal Procedure

1. Disconnect the energy storage box before servicing the vehicle.





2. Install a drain pan under the vehicle.

Notice: Refer to Power Steering Hose Disconnected Notice in Service Precautions.

3. Remove the power steering gear inlet hose (4) from the brake booster.
4. Remove the power brake booster outlet hose (3) retaining clamp (2) to remove the power brake booster hose outlet hose from the brake booster.
5. Remove the power brake booster inlet hose (1) from the brake booster.





6. Remove the power steering gear inlet hose (5) from the power steering gear.
7. Remove the power brake booster outlet hose (2) retaining clamp (3) to remove the power brake booster outlet hose from the power steering pump.
8. Remove the power brake booster inlet hose (5) from the power steering pump.
9. Remove the power steering hose assembly from the vehicle.

Installation Procedure





1. Install the booster inlet hose to the pump.

Notice: Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.

Important: Following this sequence ensures correct routing and orientation.

Important: Ensure that the hose contacts the power steering pump as shown.






2. Install the gear inlet hose to the gear (5).





3. Install the booster outlet hose to the power steering pump nipple and retaining clamp (2).





4. Install the booster inlet hose (1) to the booster.

5. Install the gear inlet hose to the booster.
^ Tighten both power steering inlet hose fittings to 32 Nm (24 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

6. Install the booster outlet hose (3) to the booster and install the retaining clamp (2).
7. Remove the drain pan from under the vehicle.
8. Bleed the power steering system.
9. Connect the energy storage box before after servicing the vehicle.