Rear Wheel Steering

Rear Wheel Steering Tie Rod End Replacement - Inner

^ Tools Required
- J 44665-2 Inner Tie Rod Wrench

Removal Procedure

Notice: Refer to Rear Wheel Steering Lifting and Jacking Notice in Service Precautions.





1. Remove the rack and pinion boot from the steering gear.
2. Remove the inner tie rod (1) from the steering gear using the J 44665-2 (2).

Installation Procedure





1. Install the inner tie rod to the steering gear.

Notice: Refer to Fastener Notice in Service Precautions.

2. Using the J 44665-2 (2) tighten the inner tie rod (1).
^ Tighten the inner tie rod to 100 Nm (74 ft. lbs.).
3. Install the rack and pinion boot to the steering gear. Refer to Rack and Pinion Boot Replacement.