EVAP Canister Replacement (1500 Crew Cab)

EVAPORATIVE EMISSION (EVAP) CANISTER REPLACEMENT (1500 CREW CAB)

REMOVAL PROCEDURE

IMPORTANT: Clean all evaporative emission (EVAP) connections and surrounding areas prior to disconnecting the lines in order to avoid possible system contamination.




1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the canister vent solenoid (CVS) line from the EVAP canister.




3. Disconnect the fuel/EVAP bundle line from the EVAP canister.
4. Disconnect the fuel tank line from the EVAP canister.
5. Remove the EVAP canister bracket bolts.
6. Remove the EVAP canister from the bracket, if necessary.

INSTALLATION PROCEDURE




1. Install the EVAP canister to the bracket, if necessary.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the EVAP canister bracket bolts.

Tighten the bolts to 18 N.m (13 lb ft).

3. Connect the fuel tank line to the EVAP canister.
4. Connect the fuel/EVAP bundle line to the EVAP canister.




5. Connect the CVS line to the EVAP canister.
6. Lower the vehicle.