Fuel Pressure Gage Installation and Removal

FUEL PRESSURE GAGE INSTALLATION AND REMOVAL

TOOLS REQUIRED
J 34730-1AFuel Pressure Gage

INSTALLATION PROCEDURE

CAUTION:
- Refer to Gasoline/Gasoline Vapors Caution in Service Precautions.
- Refer to Fuel Gage Leak Caution in Service Precautions.




1. Remove the engine sight shield.
2. Remove the fuel rail pressure cap.
3. Connect the J 34730-1A to the fuel pressure valve. Wrap a shop towel around the fitting while connecting the gage in order to avoid spillage.
4. Install the bleed hose on J 34730-1A into an approved container.

REMOVAL PROCEDURE




1. Remove the bleed hose on the J 34730-1A from the approved container.
2. Remove the shop towel from around the fitting and discard into an approved container.
3. Disconnect the J 34730-1A from the fuel pressure valve.
4. Install the fuel rail pressure fitting cap.
5. Install the engine sight shield.