Blower Motor Resistor Replacement

BLOWER MOTOR RESISTOR REPLACEMENT

REMOVAL PROCEDURE
1. If equipped, remove the IP sound insulator.




2. Disconnect the electrical connection from the blower motor.
3. Disconnect the electrical connection from the blower motor resistor.




4. Remove the blower motor resistor retaining screws.




5. Remove the blower motor resistor.

INSTALLATION PROCEDURE




1. Install the blower motor resistor.




2. Install the blower motor resistor retaining screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 1.6 N.m (14 lb in).




3. Connect the electrical connection to the blower motor resistor.
4. Connect the electrical connection to the blower motor.
5. If equipped, install the IP sound insulator.