Instrument Panel (IP) - Wiring Harness Replacement

Instrument Panel (I/P) Harness Replacement

Removal Procedure






1. Remove the I/P carrier.
2. Remove the driver's side hinge pillar trim panel.
3. Remove the driver's side seat, if equipped with power.
4. Disconnect the electrical harness from the underhood electrical center.
5. Disconnect the wire harness from the hood, if equipped with underhood camp.
6. Remove the harness grommet from the cowl.
7. Remove the I/P harness from the vehicle.

Installation Procedure






1. Install the I/P harness to the vehicle.
2. Install the harness grommet to the cowl.
3. Connect the wire harness to the hood, if equipped with underhood camp.
4. Connect the electrical harness from the underhood electrical center.
5. Install the driver's side seat, if equipped with power.
6. Install the driver's side hinge pillar trim panel.
7. Install the I/P carrier.