Steering Gear Actuator and Cover Replacement
Steering Gear Actuator and Cover Replacement
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
Notice: Refer to Rear Wheel Steering Lifting and Jacking Notice in Service Precautions.
2. Remove the tire and wheel.
3. Remove the drain plug (2) and drain the fluid from the differential housing.
4. Remove the bolts (3) retaining the steering gear protection shield.
5. Disconnect the electrical connectors from the control module (2).
6. Disconnect the electrical connector (1) from the rear position sensor.
7. Remove the outer tie rod ends from the steering knuckle.
8. Disconnect the differential vent hose (1) from the vent tube (2).
9. Remove the bolts retaining the steering gear actuator and cover (2) to the differential (1).
10. Remove the steering gear actuator and cover from the vehicle.
Installation Procedure
1. Install the steering gear actuator (2) and gasket (1) to the differential.
Important: Clean all of the sealing surfaces prior to installing the gasket. Do not reinstall the old gasket, replace the gasket whenever the actuator is removed from the axle.
2. Install the steering gear actuator and cover (2) retaining bolts.
^ Tighten the bolts to 61 Nm (45 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
3. Connect the electrical connectors to the control module (2).
4. Install the differential vent hose (1) to the vent tube (2).
5. Install the outer tie rod ends to the steering knuckle.
6. Install the drain plug (2) and fill the differential with fluid.
7. Install the bolts (3) retaining the steering gear protection shield.
^ Tighten the bolts to 180 Nm (132 ft. lbs.).
8. Install the tire and wheel.
9. Lower the vehicle.
10. Check the wheel alignment.