Rear Wheel Steering Control Module Bracket Replacement

Rear Wheel Steering Control Module Bracket Replacement

Removal Procedure





1. Remove the rear wheel steering control module (2) from the bracket.
2. Remove the nuts retaining the bracket to the frame.
3. Remove the bracket from the vehicle.

Installation Procedure





1. Install the bracket to the vehicle.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the bracket retaining nuts.
^ Tighten the retaining nuts to 25 Nm (18 ft. lbs.).
3. Install the rear wheel steering control module (2) o the bracket.
4. Perform a learn alignment. Programming and Relearning