Seat Back Cover and Pad Replacement - Rear No. 1

SEAT BACK COVER AND PAD REPLACEMENT - REAR NO. 1

REMOVAL PROCEDURE
1. Remove the seat back from the vehicle.
2. Remove the seat belt buckle bracket, on the right side only.




3. Remove the seat belt anchor bolt from the bracket.




4. Release the seat belt bezel from the seat back by pressing in the buttons (1) on the plastic retainers.
5. Remove the seat belt bezel by sliding it off the seat belt.
6. Remove the head restraints.




7. Remove the release latch knob.




8. Remove the screw that retains the seat back latch release bezel to the seat back.




9. Release the J-strips on the bottom of the seat back frame.
10. Release the hook and loop retaining strips at the bottom of the seat back.
11. Remove 3 push-pins from the bottom of the seat back.




12. Release the cover from the hook and loop retaining strips on the front of the seat back pad.

IMPORTANT: Ensure that the hook and loop retaining strips remain attached to the seat back pad.




13. Remove the 6 push-pins from the seat back.
14. Remove the cover and pad from the seat back.




15. Release the 3 hog-rings from the reinforcement bar.
16. Remove the seat cover from the pad.

INSTALLATION PROCEDURE
1. Install the seat back pad to the seat back frame.




2. Install the 6 push-pins that retain the seat back pad to the seat back frame.
3. Partially install the seat cover.




4. Install the 3 hog-rings to the reinforcement bar.
5. Install the seat cover the remainder of the way.




6. Engage the seat cover to the hook and loop retaining strips on the seat back pad.




7. Install the screw that retains the rear seat back release latch bezel to the rear seat back.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the rear seat back release latch bezel screw to 3 N.m (26 lb in).




8. Install the 3 push-pins at the bottom of the rear seat back.
9. Engage the hook and loop retaining strips at the bottom of the rear seat back.
10. Starting at either corner, engage the J-strips at the bottom of the rear seat back.
11. Install the head restraints.




12. Install the seat belt bezel to the rear seat back with the plastic retainers (2).




13. Install the rear seat belt anchor bolt into the seat belt buckle bracket.

Tighten the rear seat belt anchor bolt to 55 N.m (41 lb ft).

14. Install the seat belt buckle bracket, on the right side only.
15. Install the seat back into the vehicle.