Disconnect/Connect Procedure

BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution.

1. Record all presets and theft codes from the radio.
2. Turn off all the lamps and accessories.
3. Turn the ignition OFF.




4. Remove the battery ground (negative) cable (2) from the battery.

INSTALLATION PROCEDURE




1. Install the battery ground (negative) cable (2) to the battery.

Tighten the battery terminal bolt to 16 N.m (12 lb ft).

NOTE: Refer to Fastener Notice.

IMPORTANT: Clean any existing corrosion from the battery terminal bolt flange and the battery cable end.

2. Reprogram the radio presets. Refer to Radio Setup.
3. Re-initialize the power sliding doors. Refer to Actuator Control Module - Power Sliding Door (PSD) Programming and Setup.