Clutch Switch: Service and Repair

Clutch Pedal Cruise Control Release Switch Replacement

Removal Procedure





1. Disconnect the negative battery cable.

Caution: Refer to Battery Disconnect Caution in Service Precautions.

2. Remove the LH instrument panel (I/P) lower insulator panel.
3. Disconnect the clutch cruise control release switch electrical connector.





4. Remove the clutch cruise control release switch from the bracket.

Installation Procedure





1. Install the clutch cruise control release switch to the bracket.
2. Fully seat the switch to the bracket. Audible clicks will be heard while pushing the switch.





3. Connect the clutch cruise control release switch electrical connector.





4. Adjust the clutch cruise control release switch.
5. Grasp the clutch pedal and pull fully rearward against the pedal stop. Audible clicks may be heard as the switch moves into the adjusted position.
6. Install the LH I/P lower insulator panel.
7. Connect the negative battery cable.
Tighten the negative battery cable bolt to 15 N.m (11 lb ft).

Notice: Refer to Fastener Notice in Service Precautions.