Knock Sensor (KS) Replacement (Right)

KNOCK SENSOR (KS) REPLACEMENT (RIGHT)

REMOVAL PROCEDURE




1. Remove the negative battery cable.
2. Remove the right exhaust manifold.
3. Remove the right catalytic convertor.
4. Remove the starter assembly (4), ONLY IF NEEDED.

IMPORTANT: In the following service procedure, it maybe necessary to remove the starter assembly to gain enough clearance to remove the knock sensor.

5. Remove the knock sensor mounting (1).
6. Remove the knock sensor 2 from the engine block (5).
7. Disconnect the engine electrical connector (3) from the knock sensor 2.
8. Remove the knock sensor 2.

INSTALLATION PROCEDURE




1. Reconnect electrical connector (3) for the engine harness to the knock sensor 2.
2. Position the knock sensor 2 on the engine block (5).
3. Install the mounting bolt (1) for the knock sensor 2.
4. Tighten the knock sensor mounting bolt (1).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the knock sensor mounting bolt 1 to 20 N.m (15 lb ft).

5. Install the starter assembly (4), ONLY IF REMOVED.
6. Install the catalytic convertor.
7. Install the right exhaust manifold.
8. Program the transmitters. Refer to Transmitter Programming (Domestic and Japan) Transmitter Programming (Export - Including Canada) in Keyless Entry.

IMPORTANT: Perform the following procedure only if the battery has been disconnected.

9. Install the negative battery cable.