Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 2006 >> Corvette V8-6.0L VIN U >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Sensors and Switches - Computers and Control Systems >> Air Flow Meter/Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Air Flow Meter/Sensor: Service and Repair



MASS AIR FLOW (MAF)/INTAKE AIR TEMPERATURE (IAT) SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the electrical connector (1) for the mass air flow (MAF)/air intake temperature (IAT) sensor (5).
2. Remove the lines (2) from the air duct (4).
3. Loosen the air intake duct clamps (3).
4. Remove the air intake duct (4) from the throttle body.
5. Remove the MAF/IAT sensor (5) from the air cleaner housing (7).

INSTALLATION PROCEDURE




1. Install the MAF/IAT sensor (5) in the air cleaner housing (6).

IMPORTANT: Ensure that the arrow on the MAF/IAT sensor is pointing to the front, radiator, indicate the proper air flow direction. The arrow must point toward the engine.

2. Install the air intake duct (4).
3. Position the clamps (3) on the air intake duct (4).
4. Tighten the clamps (3).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten air intake duct and MAF/IAT sensor (2) to 4 N.m (35 lb in).

5. Reconnect the MAF/IAT electrical connector (1).
6. Reconnect the electrical connector (1).
pro multis · About Operation CHARM