Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 2006 >> Corvette V8-7.0L VIN E >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Restraints and Safety Systems >> Air Bag Control Module >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Air Bag Control Module: Service and Repair



INFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE REPLACEMENT

REMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 4.

CAUTION:
- Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
- Refer to SIR Caution in Service Precautions.

2. Remove the accessory trim plate.




3. Remove the connector position assurance (CPA) from the sensing and diagnostic module (SDM) harness connector.
4. Disconnect the SDM harness connector.




5. Remove the SDM mounting fasteners.
6. Remove the SDM from the instrument panel (I/P) center support system.

INSTALLATION PROCEDURE
1. Remove any dirt, grease, or other impurities from the mounting surface.




2. Install the SDM horizontally to the I/P center support system.
3. Point the arrow on the SDM toward the front of the vehicle.
4. Install the SDM mounting fasteners.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the fasteners to 10 N.m (89 lb in).

5. Install the SDM harness connector to the SDM.




6. Install the CPA to the SDM harness connector.
7. Install the accessory trim plate.
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 4.

IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps thoroughly to ensure that the SDM is set properly. Testing and Inspection
pro multis · About Operation CHARM