Manifold Pressure/Vacuum Sensor: Service and Repair

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the MAP sensor electrical connector.
2. Remove the MAP sensor attaching screw.
3. Remove the MAP sensor and MAP sensor seal from the upper intake manifold.

INSTALLATION PROCEDURE




1. Install the MAP sensor and MAP sensor seal into the upper intake manifold.
2. Install the MAP sensor attaching screw.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the attaching screw to 6.5 N.m (5.7 lb in).

3. Connect the MAP sensor electrical connector.