Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 2006 >> Monte Carlo V8-5.3L VIN C >> Repair and Diagnosis >> Powertrain Management >> Ignition System >> Camshaft Position Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Camshaft Position Sensor: Service and Repair



CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the camshaft position (CMP) sensor electrical connector.




2. Remove the CMP sensor bolt (705).
3. Remove the CMP sensor (703).
4. Inspect the CMP sensor O-ring seal (704) for cuts or damage. If the seal is not cut or damaged, it may be reused.
5. Remove the CMP sensor O-ring seal (704), if necessary.

INSTALLATION PROCEDURE




1. Lubricate the O-ring seal with clean engine oil.
2. Install the O-ring seal (704) onto the CMP sensor, if necessary.
3. Install the CMP sensor (703).
4. Remove the CMP sensor bolt (705).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolt to 12 N.m (106 lb in).




5. Connect the CMP sensor electrical connector.
pro multis · About Operation CHARM