Knock Sensor (KS) Replacement (Left)

KNOCK SENSOR (KS) REPLACEMENT (LEFT)

REMOVAL PROCEDURE




1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the electrical connector (1) for the knock sensor (3).
3. Remove the retaining bolt (2) for the knock sensor (3).
4. Remove the knock sensor (3).

INSTALLATION PROCEDURE




1. Position the knock sensor (3) on the engine block.
2. Install the retaining bolt (2) for the knock sensor (3).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the knock sensor retaining bolt to 20 N.m (15 lb ft).

3. Reconnect the electrical connector (1).
4. Lower the vehicle.