Shift Control Assembly Replacement

Repair Instructions

Shift Control Assembly Replacement
Removal Procedure
1. Remove the console assembly.
2. Remove the control lever handle.
3. Remove the control lever boot/grommet.
4. Remove the mounting bolts for the shift control.
5. Remove the shift control assembly.

Installation Procedure
1. Position the shift control assembly on the transmission.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the mounting bolts.
Tighten the mounting bolts to 24 Nm (18 ft. lbs.).
3. Remove the control lever boot/grommet.
4. Install the control lever handle.
5. Install the console assembly.