Switch Replacement - Door Lock and Side Window - Passenger

Switch Replacement - Door Lock and Side Window - Passenger

Removal Procedure




1. Remove the front door trim panel.
2. Remove the screw (2) that retains the switch panel bezel (1) to the front door trim panel.




3. Remove the switch panel bezel from the door panel using a flat-bladed tool.




4. Using a wide plastic flat-bladed tool, release the retaining clips on both sides of the door module.
5. Remove the door module from the switch panel bezel.

Installation Procedure




1. Install the door module into the switch panel bezel until it snaps into place.
2. Install the switch panel bezel and module into the door trim panel.

Notice: Refer to Fastener Notice in Service Precautions.




3. Install the screw (2) that retains the switch panel bezel (1) to the front door trim panel.

Tighten the screw (2) to 2 N.m (18 lb in).

4. Install the front door trim panel.
5. Perform the necessary setup and programming procedures. Refer to Door Control Module Programming and Setup in Vehicle Control Systems.