46. 1-2-3-4 Clutch Steel Plate Inspection

1-2-3-4 Clutch Steel Plate Inspection





1. Important:
^ Measure as described below at a minimum of 3 locations.
^ Replace any 1-2-3-4 clutch steel plate that does not meet specifications.

Measure the thickness of each 1-2-3-4 clutch steel plate (1) at dimension A.
The 1-2-3-4 clutch steel plate minimum thickness is 2.135 mm (0.084 inch).





2. Important: Check the plates for coning on a level surface.

Measure the cone of each plate (1) at dimension A.
The 1-2-3-4 clutch steel plate maximum cone is 0.200 mm (0.0079 inch).