Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 2009 >> Corvette V8-6.2L >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> Braking Sensor/Switch >> Service and Repair >> Brake Pedal Position Sensor Replacement
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Brake Pedal Position Sensor Replacement




Brake Pedal Position Sensor Replacement

Removal Procedure




1. Remove the instrument panel (I/P) insulator. Refer to Instrument Panel Insulator Panel Replacement (Service and Repair).
2. Disengage but do not remove the connector position assurance (CPA) on the connector.
Disconnect the electrical connector (2).




3. Remove the screw.
4. Remove the brake pedal position sensor.

Installation Procedure




1. Apply adhesive GM P/N 12345493 (Canadian P/N 10953488) to the screw.
2. Position the sensor fork to the pin.
3. Rotate the sensor in order to align the sensor locator to the hole in the extension bracket.

Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the brake pedal position sensor screw.

Tighten the screw to 2 Nm (18 lb in).




5. Connect the electrical connector (2).
Engage the CPA. The CPA will not engage if the connector is not attached properly.
6. Calibrate the sensor. Refer to Brake Pedal Position Sensor Calibration (Programming and Relearning).
7. Install the I/P insulator. Refer to Instrument Panel Insulator Panel Replacement (Service and Repair).

pro multis · About Operation CHARM