134. Exhaust Manifold Installation - Right Side

Exhaust Manifold Installation - Right Side




1. Install the engine block heater, if equipped.




2. Install a NEW crankshaft position (CKP) sensor O-ring.




3. Install the CKP sensor.





Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the CKP sensor bolt and tighten to 10 Nm (89 lb in).




5. Install the right knock sensor.




6. Install the right knock sensor bolt. Ensure the knock sensor is oriented with the harness connector positioned to the front on the right side (1) and tighten the right knock sensor bolt to 23 Nm (17 lb ft).




7. Install the right knock sensor heat shield.




8. Install the right knock sensor heat shield bolts and tighten to 50 Nm (37 lb ft).




9. Install the studs into the right cylinder head and tighten the studs to 10 Nm (89 lb in).




10. Install a NEW right exhaust manifold gasket.




11. Install the right exhaust manifold.




12. Loosely install the right exhaust manifold nuts onto the studs in the right cylinder head.




13. Loosely install the right exhaust manifold bolts into the right cylinder head.
14. Tighten the right exhaust manifold nuts and bolts to 25 Nm (18 lb ft).




15. Place the right exhaust manifold heat shield in position.




16. Install the exhaust manifold heat shield bolts and tighten to 10 Nm (89 lb in).