Knock Sensor Replacement - Bank 1

Knock Sensor Replacement - Bank 1

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the radiator air baffle. Refer to Radiator Air Baffle Assemblies and Deflectors Radiator Air Baffle Assemblies and Deflectors.
3. Disconnect the engine harness electrical connector (1) from the knock sensor.




4. Loosen and remove the bank 1 knock sensor (1).

Installation Procedure





Caution: Refer to Fastener Caution Fastener Caution.

Note: DO NOT apply thread sealant to the sensor threads. The sensor threads are coated at the factory. Applying additional sealant affects the sensors ability to detect detonation.

1. Install and tighten the bank 1 knock sensor (1) to 25 Nm (18 lb ft).




2. Connect the engine harness electrical connector (1) to the knock sensor.
3. Install the radiator air baffle. Refer to Radiator Air Baffle Assemblies and Deflectors Radiator Air Baffle Assemblies and Deflectors.
4. Lower the vehicle.