Shift Linkage: Service and Repair

Automatic Transmission Range Selector Lever Replacement

Removal Procedure

1. Apply the parking brake and place the control assembly in Neutral. The transaxle manual shaft must be in the Neutral position prior to installing the range switch.




2. Remove the shift control cable from the transaxle range switch lever.





Warning

Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.

3. Remove the transaxle range switch lever nut and lever.

Installation Procedure




1. Make sure the transaxle manual shaft is in the Neutral position.





Warning

Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the transaxle range switch lever and nut and tighten to 35 Nm (26 lb ft).
3. Install the shift control cable to transaxle range switch lever and verify proper operation.