Rear Suspension

Stabilizer Shaft Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Lower the rear suspension support. Refer to Rear Support Replacement (AWD) (Rear Support Replacement)Rear Support Replacement (FWD) (Rear Support Replacement).





Note: Hold the ball shaft secure with a TORX(R) bit, when removing the nut.

3. Remove the stabilizer link to stabilizer shaft nut.




4. Remove the stabilizer shaft clamp bolts.
5. Remove the stabilizer shaft clamps and bushings from the stabilizer shaft.
6. Disengage the stabilizer shaft from the stabilizer link ball studs, while removing the stabilizer shaft from the vehicle.

Installation Procedure

1. Position the stabilizer shaft in the vehicle, while positioning the links to the stabilizer bar.
2. Install the stabilizer shaft clamps and bushings to the stabilizer shaft.





Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the stabilizer shaft clamp bolts and tighten to 70 Nm (52 lb ft).





Note: Hold the ball shaft secure with a TORX(R) bit, when installing the nut.

4. Install the stabilizer link to stabilizer shaft nut and tighten to 50 Nm (37 lb ft).
5. Lower the vehicle.