VIN 6

Plastic Collar Quick Connect Fitting Service

Disconnect Procedure





Note: There are several types of Plastic Collar Fuel and Evaporative Emission Quick Connect Fittings used on this vehicle.

* Bartholomew (1)
* Q Release (2)
* Squeeze to Release (3)
* Sliding Retainer (4)
* Push Down TI (5)

The following instructions apply to all of these types of Plastic Collar Quick Connect Fittings except where indicated.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Battery Negative Cable Disconnection and Connection).




Warning: Refer to Safety Glasses Warning (Safety Glasses Warning).

2. Using compressed air, blow any dirt or debris from around the connection.




3. This step applies to Bartholomew style connector ONLY. Squeeze the plastic quick connect fitting release tabs.




4. This step applies to Release Tab style connector ONLY. Release the fitting by pushing the tab toward the other side of the slot in the fitting.




5. This step applies to the Squeeze to Release style connector ONLY. Squeeze where indicated by the arrows shown above on both sides of the plastic ring surrounding the quick connect fitting.




6. This step applies to the Sliding Retainer style connector ONLY. Release the fitting by pressing on one side of the release tab causing it to push in slightly. If the tab does not move try pressing the tab in from the opposite side. The tab will only move in one direction.




7. This step applies to the Push Down TI style connector ONLY. Release the fitting by pressing on the tab indicated by the arrow.

Quick Connect Fittings:

8. Pull the connection apart.

Connect Procedure




Warning: Refer to Fuel Pipe Fitting Warning (Fuel Pipe Fitting Warning).

1. Apply a few drops of clean engine oil to the male connection end.




2. Push both sides of the quick-connect fitting together in order to cause the retaining feature to snap into place.




3. Once installed, pull on both sides of the connection in order to make sure the connection is secure.
4. Install the fuel fill cap.
5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Battery Negative Cable Disconnection and Connection).