VIN 6

Glow Plug Control Module Replacement

Removal Procedure




1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Battery Negative Cable Disconnection and Connection).
2. Remove the engine cover. Refer to Engine Cover Replacement (Service and Repair).
3. Disconnect the engine wiring harness electrical connector (1) from the glow plug control module.




4. Disconnect the positive battery cable (1) from the glow plug control module.




5. Remove the glow plug control module bolts (1).
6. Remove the glow plug control module (2).
7. Remove the glow plug control module bracket bolts (3), if required.
8. Remove the glow plug control module bracket (4), if required.

Installation Procedure




1. Position the glow plug control module bracket (4), if required.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the glow plug control module bracket bolts (3), if required. Tighten the bolts to 10 Nm (89 lb in).
3. Position the glow plug control module (2).
4. Install the glow plug control module bolts (1) and tighten to 10 Nm (89 lb in).




5. Connect the positive battery cable (1) to the glow plug control module.




6. Connect the engine wiring harness electrical connector (1) to the glow plug control module.
7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Battery Negative Cable Disconnection and Connection).
8. If a NEW glow plug control module was installed, program the module. Refer to Control Module References (Programming and Relearning).
9. Install the engine cover. Refer to Engine Cover Replacement (Service and Repair).