Turn Signal Multifunction Switch Replacement

Turn Signal Multifunction Switch Replacement

Removal Procedure

Warning: Refer to SIR Warning (SIR Warning).

1. Disable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair).
2. Remove the steering wheel. Refer to Steering Wheel Replacement (Steering Wheel Replacement).
3. Remove the upper and lower trim covers. Refer to Steering Column Trim Cover Replacement (Steering Column Trim Cover Replacement).
4. Disconnect the turn signal and multifunction switch assembly connector.




5. Remove the 2 screws (1) from the turn signal and multifunction switch assembly (2).
6. Remove the turn signal and multifunction switch assembly from the steering column tilt head assembly.

Installation Procedure




1. Install the turn signal and multifunction switch assembly (2) to the steering column tilt head assembly.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the 2 screws (1) to the turn signal and multifunction assembly and tighten to 3 Nm (27 lb in).
3. Connect the turn signal and multifunction switch assembly connector.
4. Install the upper and lower trim covers. Refer to Steering Column Trim Cover Replacement (Steering Column Trim Cover Replacement).
5. Install the steering wheel. Refer to Steering Wheel Replacement (Steering Wheel Replacement).
6. Enable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair).