Power Steering Pump Pulley Replacement

Power Steering Pump Pulley Replacement (6.6L)

Special Tools
* J 25033-C Power Steering Pump Pulley Installer
* J 25034-C Power Steering Pump Pulley Remover

Removal Procedure

1. Remove the accessory drive belt. Refer to Drive Belt Replacement (Service and Repair).




2. Remove the power steering pump front bracket bolts (1, 2).




3. Remove the power steering pump rear bracket bolts (1).




4. Use the J 25034-C to remove the power steering pump pulley.
5. Pull the power steering pump away from the accessory bracket to gain access to the pulley.

Installation Procedure




1. Place the power steering pump pulley on the end of the power steering pump shaft.
2. Install the power steering pump pulley using the J 25033-C .




3. Ensure that the power steering pump pulley (1) is flush against the power steering pump shaft (2) with an allowable variance of 0.25 mm (0.010 in).
4. Reposition the power steering pump to the accessory bracket.





Caution: Refer to Fastener Caution (Fastener Caution).

5. Install the power steering pump rear bracket bolts (1).

Tighten the rear bracket bolts to 50 Nm (37 lb ft).




6. Install the power steering pump front bracket bolts (1, 2).

Tighten the front bracket bolts to 50 Nm (37 lb ft).

7. Install the accessory drive belt. Refer to Drive Belt Replacement (Service and Repair).