43. 1-2-3-4 and 4-5-6 Clutch Housing Reluctor Wheel Replacement

1-2-3-4 and 4-5-6 Clutch Housing Reluctor Wheel Replacement

Special Tools
* J 43767 - Tone Wheel Staker
* J 43768 - Tone Wheel Driver

For equivalent regional tools, refer to Special Tools (Tools and Equipment).

Removal Procedure




1. Grind the stakes from the 1-2-3-4, 4-5-6 clutch housing (1).




2. Position the 1-2-3-4, 4-5-6 clutch housing (2) on a press so that the front of the housing is down.
3. Install J 43768 - driver (1) onto the tone wheel (3).
4. Using J 43768 - driver (1), press the tone wheel (3) from the 1-2-3-4, 4-5-6 clutch housing (2).

Installation Procedure




1. Position the 1-2-3-4, 4-5-6 clutch housing (3) on a press so that the front of the housing is facing up.
2. Align the tone wheel (2) so that the outside edge is facing up.
3. Install the tone wheel (2) onto the 1-2-3-4, 4-5-6 clutch housing.
4. Install J 43768 - driver (1) onto the tone wheel.
5. Using J 43768 - driver (1), press the tone wheel onto the 1-2-3-4, 4-5-6 clutch housing.




6. Locate 4 positions on the 1-2-3-4, 4-5-6 clutch housing (3), 90 degrees apart from each other, that have not been previously staked.
7. Install J 43767 - staker onto the 1-2-3-4, 4-5-6 clutch housing with the 2 staking prongs at 2 of the 4 staking positions.
8. Install J 43768 - driver (1) onto J 43767 - staker (2).

Caution: Stake the tone wheel to 9 tons. The accuracy of the pressure gauges on presses varies. Start at a lower pressure and increase to 9 tons. Too great a pressure will distort the tone wheel. Too little pressure will result in stakes that will not hold.

9. Stake the tone wheel to the 1-2-3-4, 4-5-6 clutch housing.

Note: If necessary, tap J 43768 - driver and J 43767 - staker to remove the tools from the 1-2-3-4, 4-5-6 clutch housing.

10. Remove the J tools and repeat steps 7-9 at the remaining 2 staking positions.
11. Remove the J tools.