B3105

DTC B3105

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC B3105
- Keyless Entry System Key Fobs Not Programmed

Circuit/System Description

The remote control door lock receiver (RCDLR) monitors the number of keyless entry transmitters programmed. Until at least one transmitter is programmed, the RCDLR determines a malfunction condition exists.

Conditions for Running the DTC

The keyless entry system must be enabled.

Conditions for Setting the DTC

The DTC is set if there are no keyless entry transmitter programmed to the RCDLR.

Action Taken When the DTC Sets

The keyless entry system is inoperative.

Conditions for Clearing the DTC

A current DTC is cleared at least one transmitter has been programmed to the RCDLR.

Reference Information
Schematic Reference

Remote Function Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Keyless Entry System Description and Operation (with Accessory 2 Way Remote) (Keyless Entry System (with Accessory 2 Way Remote))Keyless Entry System Description and Operation (without Accessory 2 Way Remote) (Keyless Entry System (without Accessory 2 Way Remote))
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information
Special Tools

J 43241 Keyless Entry Tester

Circuit/System Verification

Attempt to program the keyless entry transmitter, refer to Remote Control Door Lock Transmitter Programming (Testing and Inspection). The transmitter should program.

Circuit/System Testing

1. Verify that the transmitter is the correct transmitter for the vehicle.

• If not correct, replace the transmitter.

2. Place the transmitter on the test pad of the J 43241 and press each button of the transmitter one at a time. The tester should sound a tone and illuminate a green light when each button is pressed.

• If one or more buttons does not sound the tone and illuminate the green light, replace the transmitter battery and retest with the J 43241 . If the condition continues after battery replacement, replace the transmitter.

3. Attempt to program the transmitter, refer to Remote Control Door Lock Transmitter Programming (Testing and Inspection). The transmitter should program.

• If the transmitter does not program, test the keyless entry antenna for an open/high resistance. If the circuit tests normal, replace the RCDLR.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for RCDLR replacement, setup, and programming