110. Four-Wheel-Drive Output Shaft Retaining Nut Installation

Four-Wheel-Drive Output Shaft Retaining Nut Installation

Special Tools

J 43769 - Spanner Nut Wrench - 4WD

For equivalent regional tools, refer to Special Tools (Tools and Equipment).




1. The fullest clockwise position of the manual shift shaft is Park (P), which engages the park pawl.
2. Using a wrench on the manual shift shaft flats (1), rotate the shaft to the fullest clockwise position.




3. Ensure the park pawl is engaged.
4. Install the J 43769 - wrench (1) onto the output shaft retaining nut, 4WD (2).

Caution: Refer to Fastener Caution (Fastener Caution).

5. Using the J 43769 - wrench (1), install a new output shaft retaining nut, 4WD (2) onto the output shaft (3). Tighten the nut to 61 Nm (45 lb ft).





Note: The Neutral (N) position of the manual shift shaft is 2 detent positions counterclockwise from the fullest clockwise position.

6. Using a wrench on the manual shift shaft flats (1), rotate the shaft to the fullest clockwise position.
7. Rotate the manual shift shaft counterclockwise 2 detent positions.
8. Make sure the park pawl is disengaged.