Front Axle Vent Hose Connector Replacement (8.25 Inch Axle)

Front Axle Vent Hose Connector Replacement (8.25 Inch Axle)

Removal Procedure




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the front differential carrier shield, if equipped. Refer to Shield Replacement (Service and Repair).
3. Remove the vent hose (1).
4. Remove the vent hose connector (2).

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the vent hose connector (2). Apply a small amount of sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the threads.

Tighten the vent connector to 20 Nm (15 lb ft).

2. Install the vent hose (1).
3. Install the front differential carrier shield, if equipped. Refer to Shield Replacement (Service and Repair).
4. Lower the vehicle.