Electronic Suspension Front Position Sensor Link Assembly Replacement

Electronic Suspension Front Position Sensor Link Assembly Replacement

Tools Required

J 38185 Spring Hose Clamp Pliers

Removal Procedure

Important: Do not attempt to pry the link rod from the electronic suspension control (ESC) ball stud. If the link rod needs to be replaced or disconnected, you must use the following procedure.


1. Remove the ESC sensor from the vehicle. Refer to Electronic Suspension Front Position Sensor Replacement (Electronic Suspension Front Position Sensor Replacement).
2. While supporting the sensor lever by hand, twist the link rod to remove it from the ball stud.
3. Remove the link rod from the mounting bracket ball stud.

Installation Procedure




1. Using the J 38185 install to link rod to the ball stud on the sensor lever and the mounting bracket.
2. Install the ESC sensor to the vehicle. Refer to Electronic Suspension Front Position Sensor Replacement (Electronic Suspension Front Position Sensor Replacement).