Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay $250), please get in contact with us ASAP: email operation-charm [[at]] tuta.io or click to submit anonymously. (I know, we said we wouldn't ask any more...but it's important!)

132. Crankshaft Balancer Installation

Crankshaft Balancer Installation

Special Tools
* EN-46106 - Engine Flywheel Holding Tool
* J-41998-B - Crankshaft Balancer Installer
* J-45059 - Angle Meter
For equivalent regional tools, refer to Special Tools (Special Tools).

1. The EN-46106 - tool must be installed onto the flywheel.
2. Use the J-41998-B - installer, nut, bearing and washer to install the crankshaft balancer.

Note: Do not lubricate the crankshaft front oil seal or crankshaft balancer sealing surfaces. The crankshaft balancer is installed into a dry seal.

3. Apply lubricant to the inside of the crankshaft balancer hub bore.

4. Place the crankshaft balancer in position on the crankshaft.
5. Thread the J-41998-B - installer in the crankshaft. Ensure you engage at least 10 threads of the J-41998-B - installer before pressing the crankshaft balancer in place.
6. Push the crankshaft balancer into position by tightening the nut on the J-41998-B - installer until the large washer bottoms out on the crankshaft end.
7. Remove the J-41998-B - installer.

8. Install the crankshaft balancer bolt.

Caution: Refer to Fastener Caution (Fastener Caution).

9. Tighten the crankshaft balancer bolt to 100 Nm (74 lb ft) and an additional 150 degrees using the J-45059 - meter.

10. Remove the EN-46106 - tool.