Vent Valve Lever Replacement (Left Hand Drive)

Vent Valve Lever Replacement (Left Hand Drive)

Removal Procedure

1. Remove instrument panel assembly. Refer to Instrument Panel Assembly Replacement (Instrument Panel Assembly Replacement).




2. Disconnect electrical connector and remove 3 mode control cam actuator screws (2) and remove mode control cam actuator (1).





Note: The graphic shows air inlet housing without attaching parts for better clarity.

3. Remove air inlet valve and inside air valve control cam (1).




4. Remove 2 vent valve levers (1).

Installation Procedure




1. Install 2 vent valve levers (1).





Note: The vent valve levers have to be fitted to the according vent valve gears in figured position. The air circulation dampers have to be in middle position.

2. Make sure that mode valve gears of vent valve levers (1) are fitted as shown in graphic above.





Note: The air inlet valve and inside air valve control cam can only be fitted in one position.

3. Install air inlet valve and inside air valve control cam (1).





Caution: Refer to Fastener Caution (Fastener Caution).

4. Install mode control cam actuator (1) and Install 3 mode control cam actuator screws (2) and connect electrical connector.

2.5 Nm (23 lb in)

5. Install instrument panel assembly. Refer to Instrument Panel Assembly Replacement (Instrument Panel Assembly Replacement).