Ignition Lock Cylinder Case Replacement

Ignition Lock Cylinder Case Replacement

Removal Procedure

Warning: Refer to SIR Warning (SIR Warning).

1. Disable the SIR system. Refer to SIR Disabling and Enabling .
2. Remove the ignition switch. Refer to Ignition and Start Switch Replacement (Service and Repair).
3. Remove the turn signal cancel cam. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement).
4. Remove the park lock cable from the lock cylinder housing.




5. Remove 3 TORX(R) screws.
6. Remove the lock cylinder housing from the steering column.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install 3 TORX(R) screws into the lock cylinder housing and tighten to 7 Nm (62 lb in).
2. Install the turn signal cancel cam. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement).
3. Install the park lock cable into the lock cylinder housing.
4. Install the ignition switch. Refer to Ignition and Start Switch Replacement (Service and Repair).
5. Enable the SIR system. Refer to SIR Disabling and Enabling .
6. Refer to Control Module References (Programming and Relearning) for programming and setup information.