P150C

DTC P150C

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC P150C
- Transmission Control Module (TCM) Engine Speed Request Circuit

Circuit/System Description

The TCM and the engine control module (ECM) monitor the number of Engine Speed Request Circuit serial data messages transmitted/received between modules. If the ECM detects a faulty message count, DTC P0150C sets.

Conditions for Running the DTC

Engine running.

* No Idle Speed DTC P0506 or P0507
* No Serial communication DTC U0101

Conditions for Setting the DTC

The ECM detects greater than 3 message count errors.

Action Taken When the DTC Sets

* The ECM Disables engine speed requests from transmission.
* DTC P150C is a type B DTC.

Conditions for Clearing the DTC

DTC P150C is a type B DTC.

Diagnostic Aids

Default actions for U-codes may set this DTC.

Reference Information
Connector End View Reference

* Component Connector End Views (Connector End Views By Name)
* Inline Harness Connector End Views (Connector End Views By Number)

Description and Operation

Data Link Communications Description and Operation (Description and Operation)
DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Powertrain Diagnostic Trouble Code (DTC) Type Definitions)
Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

1. If any other DTC's are set, diagnose those first.
2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

• If the DTC resets, replace the TCM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for TCM replacement, setup, and programming.