Rear Suspension

Rear Wheel Bearing and Hub Replacement

Removal Procedure

Note: The wheel bearing in the rear wheel hub is integrated into one unit. The hub is non-serviceable. If the hub and/or bearing is damaged, replace the complete hub and bearing assembly.

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the tires and wheels. Refer to Tire and Wheel Removal and Installation (Service and Repair).
3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement (Rear Brake Rotor Replacement).




4. Remove the ABS electrical connector from the wheel speed sensor (1), if equipped.
5. Remove the park brake cable from the park brake actuator. Refer to Parking Brake Rear Cable Replacement (Z7U) (Parking Brake Rear Cable Replacement (Z7U)).
6. Remove the mounting bolts from the rear bearing/hub.




7. Remove the wheel bearing/hub and park brake assembly from the knuckle.
8. Remove the park brake actuator from the rear wheel bearing/hub. Refer to Parking Brake Actuator Replacement (Service and Repair).

Installation Procedure




1. Install the park brake actuator to the rear wheel bearing/hub. Refer to Parking Brake Actuator Replacement (Service and Repair).
2. Install the wheel bearing/hub and park brake assembly to the knuckle.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the wheel bearing/hub-to-knuckle bolts.

Tighten the bolts to 75 Nm (55 lb ft).

4. Install the park brake cable to the park brake actuator. Refer to Parking Brake Rear Cable Replacement (Z7U) (Parking Brake Rear Cable Replacement (Z7U)).




5. Install the ABS electrical connector to the wheel speed sensor (1), if equipped.
6. Install the brake rotor. Refer to Rear Brake Rotor Replacement (Rear Brake Rotor Replacement).
7. Install the tires and wheels. Refer to Tire and Wheel Removal and Installation (Service and Repair).
8. Lower the vehicle.