86. Engine Block Valley Cover Installation

Engine Block Valley Cover Installation





Note:
All gasket surfaces should be free of oil or other foreign material during assembly.

1. Lubricate the O-ring seals (537) with clean engine oil.

2. Install the O-ring seals (537) to the cover.





Caution:
Refer to Fastener Caution Fastener Caution.

3. Install the cover (555), gasket (556), and bolts (506). Tighten the cover bolts to 25 Nm (18 lb ft).





4. Apply sealant to the threads of the sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers Adhesives, Fluids, Lubricants, and Sealers for recommended sealant.

5. Install the oil pressure sensor (706) and sealing washer (707). Tighten the sensor to 35 Nm (26 lb ft).