Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake

Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake

Removal Procedure

1. Ignition OFF.

Warning:
Refer to Battery Disconnect Warning Service Precautions.


2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.

3. Remove the intake manifold sight shield.

4. Remove the intake manifold. Refer to Intake Manifold Replacement Intake Manifold Replacement

5. Remove the water outlet housing.





Warning:
Refer to Safety Glasses Warning Safety Glasses Warning.


6. Use compressed air to remove debris from the CMP sensor and surrounding cavities.

7. Remove the camshaft position (CMP) sensor electrical connector (1) from the CMP sensor (2).





8. Remove the CMP sensor to engine front cover retaining bolt (1).

9. Remove the CMP sensor (2) from the engine.

Installation Procedure





1. Install the CMP sensor (2) to the engine.

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the CMP sensor to engine front cover retaining bolt (1) and tighten to 10 Nm (89 lb in).





3. Install the CMP sensor electrical connector (1) to the CMP sensor (2).

4. Install the water outlet housing.

5. Install the intake manifold. Refer to Intake Manifold Replacement Intake Manifold Replacement.

6. Install the intake manifold sight shield.

7. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.