Steering Linkage Outer Tie Rod Replacement

Steering Linkage Outer Tie Rod Replacement

Special Tools

J 24319-B - Steering Linkage and Tie Rod Puller

Removal Procedure





1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation Service and Repair.

3. Remove the outer tie rod stud retaining nut.





4. Loosen the jam nut (2) on the inner tie rod (1).





5. Disconnect the outer tie rod from the steering knuckle using J 24319-B - steering linkage and tie rod puller.





6. Remove the outer tie rod (3) from the inner tie rod (1).

Installation Procedure





1. Connect the outer tie rod (3) to the inner tie rod (1). Do not tighten the jam nut (2).





2. Connect the outer tie rod to the steering knuckle.

Caution:
Refer to Fastener Caution Fastener Caution.

3. Install the outer tie rod retaining nut and tighten to 63 Nm (47 lb ft).

Note:
Be sure the power steering gear boot is not twisted after the toe adjustment.

4. Check the wheel alignment. Refer to Wheel Alignment Measurement Wheel Alignment Measurement.