Fuel Pump Flow Control Module Replacement

Fuel Pump Flow Control Module Replacement

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Disconnect the chassis wiring harness electrical connector (2) from the fuel pump flow control module (1).





3. Remove the fuel pump flow control module bolts (1).

4. Remove the fuel pump flow control module (2) from the frame.

Installation Procedure





1. Place the fuel pump flow control module (2) against the frame.

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the fuel pump flow control module bolts (1) and tighten to 9 Nm (80 lb in).





3. Connect the chassis wiring harness electrical connector (1) to the fuel pump flow control module (2).

4. Lower the vehicle.

5. Program the fuel pump flow control module. Refer to Control Module References Control Module References.