Automatic Transmission Flex Plate Installation

Automatic Transmission Flex Plate Installation

Special Tools

* EN-50792 - Flywheel Holding Tool

* EN-45059 - Angle Meter

For equivalent regional tools, refer to Special Tools Special Tools.





Caution: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

Note: Fasteners have adhesive patch and must be tightened to final torque within 5 minutes.

1. Install the flywheel (2) and hand start NEW bolts (1).




2. To prevent crankshaft rotation, install EN-50792 - flywheel holding tool (2) and starter motor bolts (1) at the starter motor location and engaging the flywheel.





Caution: Refer to Fastener Caution Fastener Caution.

3. Tighten the bolts evenly using the following procedure:

1. Tighten the bolts a first pass in sequence to 20 Nm (15 lb ft).

2. Tighten the bolts a second pass in sequence to 30 Nm (22 lb ft).

3. Tighten the bolts a final pass in sequence 40 degrees using the EN-45059 - meter.

4. Remove EN-50792 - flywheel holding tool.